Programming the Entone URC 4 Remote

Programming the Entone Remote to the STB (RF)

Programming Entone remote to Set Top Box (RF for 2nd stream)

1. Press and hold the STB button on the remote for approx 5 seconds.  The STB button backlight will illuminate.
URC 4 User Guide v2 6 NTSC-9

2. On the remote, press the STB button once again. Both the STB and the AUX button backlights will illuminate.
URC 4 User Guide v2 6 NTSC-10URC 4 User Guide v2 6 NTSC-11 

3. Press 2 to set the remote to RF.

Programming the Entone Remote to the STB (IR)

Programming Entone remote to Set Top Box (IR)

1. Press and hold the STB button on the remote for approx 5 seconds.  The STB button backlight will illuminate.
URC 4 User Guide v2 6 NTSC-9

2. On the remote, press the STB button once again. Both the STB and the AUX button backlights will illuminate.
URC 4 User Guide v2 6 NTSC-10URC 4 User Guide v2 6 NTSC-11 

3. Press 0 to set the remote to IR.

Programming the Entone Remote to TV

Programming Entone Remote to Television using Codes.

1. Hold down the "TV" key for 5 seconds. The button will illuminate.

2. Enter the 4 digit code for your device. The button backlight should blink twice.  If you enter an invalid code, the button will blink 7 times and the program mode will teminate.

3. Aim the remote at the TV and press "POWER" once.  The TV should turn off.  If not, repeat the above steps.

Programming Entone Remote to Television using Auto-Scan Method

1. Hold down the "TV" key for 5 seconds.  The button will illuminate.

2. Press the "POWER" key once.

3. Aim the remote at the TV, and press either "CH UP" or "CH DOWN" to start the auto-scan.

4. If the TV turns off, press the "OK" button to lock in the code.

Entone TV Codes

Please download this PDF for all of the remote codes.

Login Form